Max delay tolerances ±2 nS or ±5% whichever is greater All delays measured at 1.5V level on leading edge, no load (enable = "0"), at 25°C, 5.0Vdc
DC Electrical Characteristics Parameter Test Conditions
VOH VOL VIK IIH IIL IOS ICCH ICCL TRO NH NL High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current Low-Level Input Current Short Circuit Output Current High-Level Supply Current Low-Level Supply Current Output Rise Time Fanout High-Level Output Fanout Low-Level Output
Schematic Min Max Unit
0.5 -1.2 10 15 15 -100 V V V mA mA mA mA
INPUT DATA VCC 16 A 11 B 10 C 9
VCC = min. VIL = max. I OH = max 2.7 VCC = min. VIH = min. IOL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V VCC = max. VIN = 0.5V VCC = max. VOUT = 0. -40 (One output at a time) VCC = max. VIN = OPEN VCC = max. VIN = 0 Td 500 nS (0.75 to 2.4 Volts) VCC = max. VOH = 2.7V VCC = max. VOL = 0.5V
Programmable Delay Line
45 mA 90 mA 4 nS 20 TTL LOAD 10 TTL LOAD
4
5
7 E
8 G
IN OUT
Recommended Operating Conditions
VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature
Package Min
4. 75 2. 0
Max
5.25 0.8 -18 -1.0 20
Unit
V V V mA mA mA % % °C
.250 Max. .020 Typ.
PCA EP8076-1 Date Code White Dot Pin#1 .88 Max.
.280 Max.
100 0 20 +70
*These two values are inter-dependent.
.020 .040 .010 ± .002 .100 .150 Typ. .365 Max.
Input Pulse Test Conditions
EIN PW TRI PRR VCC Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td 500 nS Supply Voltage 3.2 150 2.0 1.0 5.0
